All vehicles

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Lubricate the steering column lock lever actuators with premium long-life grease.

Fig 1: Identifying Steering Column Lower Lock Actuator
Courtesy of FORD MOTOR CO.
Install the upper and the lower steering column lock lever actuators.

Fig 2: Identifying Upper And Lower Steering Column Lock Lever Actuators

Courtesy of FORD MOTOR CO.

Install the steering column lower bearing retainer.
- Position the steering column lower bearing retainer.
- Install the bolts and tighten to 9 Nm (80 lb-in).

NOTE: The UP position of the bearing must be facing forward.

Fig 3: Installing Steering Column Bearing And Sleeve

Courtesy of FORD MOTOR CO.

Item	Part Number	Description
1	-	Outer race
2	3517	Bearing (in the UP position)
3	-	Ball
4	-	Inner race

Install the steering column bearing and sleeve.

CAUTION: Install the steering column bearing so that the inner race is visible when installed.

NOTE: Use an appropriate bearing installer or socket.

Install the steering column bearing in the steering column lock cylinder housing.

Item	Part Number	Description
1	-	Outer race
2	-	Bearing (in the UP position)
3	-	Ball
4	-	Inner race

Fig 4: Installing Steering Column Bearing And Sleeve

Courtesy of FORD MOTOR CO.

Fig 5: Installing Steering Column Bearing In Steering Column Lock Cylinder Housing

Courtesy of FORD MOTOR CO.

Position the steering column shaft in the steering column lock cylinder housing.
- Install the steering column bearing tolerance ring on the steering column shaft.
Fig 1: Locating Steering Column Bearing Tolerance Ring
Courtesy of FORD MOTOR CO.
Install the steering column bearing sleeve.

Fig 2: Locating Steering Column Bearing Sleeve
Courtesy of FORD MOTOR CO.
Install the steering column upper bearing spring.

Fig 3: Locating Steering Column Bearing Spring
Courtesy of FORD MOTOR CO.
Install the snap ring.

Fig 4: Locating Snap Ring
Courtesy of FORD MOTOR CO.

CAUTION: The turn signal cancel cam has a flat surface and a surface that has 4 lobes. Make sure to install the cam with the flat surface upwards. Push the cam onto the shaft until it makes contact with the snap ring.

Fig 5: Installing Turn Signal Cancel Cam

Courtesy of FORD MOTOR CO.

Install the turn signal cancel cam.
Install the lock cylinder housing screws loosely and position the steering actuator housing in a vise.
- Lubricate the lock cylinder housing with premium long-life grease.
Fig 6: Locating Lock Cylinder Housing Screws
Courtesy of FORD MOTOR CO.

NOTE: Lubricate the lock cylinder housing bushings with premium long-life grease.

Fig 7: Locating Lock Cylinder Housing And Shaft On Actuator Housing

Courtesy of FORD MOTOR CO.

Position the steering column lock cylinder housing and the steering column shaft on the steering actuator housing.
- Make sure the upper and lower steering column lock actuators are aligned.
Position the steering column locking levers on the steering actuator housing.
- Using a shop fabricated tool, position the steering column locking levers.
- On tilt steering columns, install and compress the steering column position spring.
Fig 8: Identifying Shop Fabricated Tool & Steering Column Position Spring
Courtesy of FORD MOTOR CO.

Install the steering column bearing tolerance ring.

Fig 1: Locating Steering Column Bearing Tolerance Ring
Courtesy of FORD MOTOR CO.