LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1916 (Power Steering System - F250-F550) >> Removal And Installation >> Steering Gear >> Removal And Installation >> F-250, F-350 vehicles

F-250, F-350 vehicles

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: The steering gear bolts have a dry adhesive on the threads. The bolts must not be reused.
    Fig 1: Identifying Steering Gear Bolts
    GF0007741Courtesy of FORD MOTOR CO.
  1. Remove the 3 bolts and the steering gear.
    • Discard the bolts.
    • To install, tighten to 150 Nm (111 lb-ft).


  1. Using the special tool, remove the sector shaft arm.
    Fig 1: Identifying Sector Shaft Arm Using Special Tool
    GF0007742Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals