LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1914 (Windows And Glass -- F250-F550 Super Duty) >> Removal And Installation >> Window Glass - Rear >> Removal >> Vehicles with power sliding window

Vehicles with power sliding window

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The power sliding window should be partially open to carry out this procedure.
NOTE: Left side shown, right side similar.
NOTE: The right side must have the trough cover removed prior to carrying out this step.
  1. Remove the left transition block and rubber stop from the sliding window trough.
    Fig 1: Locating Rear Sliding Window Trough
    G03925737Courtesy of FORD MOTOR CO.
  2. Remove the left transition block from the cable end.
    Fig 2: Locating Left Transition Block From Cable End
    GF0005198Courtesy of FORD MOTOR CO.
  3. Disconnect the swag from the power sliding window.
  4. Pull the left cable end out of the sliding window trough.
    Fig 3: Pulling Left Cable End Out Of Sliding Window Trough
    GF0005199Courtesy of FORD MOTOR CO.
  5. Repeat Steps for the right side.
scientia non olet · About LEMON Manuals