LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1914 (Windows And Glass -- F250-F550 Super Duty) >> Removal And Installation >> Window Glass - Rear >> Installation >> Vehicles with power sliding window

Vehicles with power sliding window

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Left side shown, right side similar.
    Fig 1: Installing Left Cable End Into Sliding Window Trough
    GF0005199Courtesy of FORD MOTOR CO.
  1. Install the left cable end into the sliding window trough.
  2. Install the left transition block on the cable end.
    Fig 2: Installing Left Transition Block On Cable End
    GF0005205Courtesy of FORD MOTOR CO.
  3. Install the LH cable swag into the rear sliding window.
    NOTE: The right side must have the trough cover installed after carrying out this step.
    Fig 3: Installing LH Cable Swag Into Rear Sliding Window
    GF0005206Courtesy of FORD MOTOR CO.
  4. Install the left transition block and rubber stop in the rear sliding window trough.
    Fig 4: Locating Rear Sliding Window Trough
    G03925737Courtesy of FORD MOTOR CO.
  5. Repeat Steps for the right side.
scientia non olet · About LEMON Manuals