LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1913 (Clutch System -- F250-F550 Super Duty) >> Removal And Installation >> Pilot Bearing >> Removal

Pilot Bearing: Removal

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the clutch disc and pressure plate. For additional information, refer to the procedure in this article.
  2. Using the special tools, remove and discard the transmission input shaft pilot bearing.
    Fig 1: Identifying Special Tools
    GF0007150Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals