Flywheel Ring Gear: Installation
WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
This procedure should be carried out only by a correctly equipped and experienced acetylene torch operator. Use tongs or wear welding gloves and safety goggles when handling hot components. Failure to follow these instructions may result in serious personal injury.
- Heat the entire flywheel ring gear evenly.
- Using a brass drift and a hammer, install the flywheel ring gear.
- Install the flywheel. For additional information, refer to ENGINE - 5.4L (3V) article, ENGINE - 6.8L (3V) article or ENGINE - 6.0L DIESEL article.
CAUTION:
Do not heat the flywheel ring gear above 278°C (500°F). Use heat indicating crayons to prevent overheating.
CAUTION:
Keep the torch moving to prevent hot spots.
CAUTION:
The bevel on the ring gear must face the rear of the flywheel.
CAUTION:
Tap evenly around the ring gear to prevent binding.