LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1910 (Automatic Transmission - 5R110W -- F250-F550 Super Duty) >> In-Vehicle Servicing >> Transmission Filler Tube >> Installation

Transmission Filler Tube: Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install a new O-ring, if damaged.
    2. Fig 1: Locating O-Ring Seal
    G03889046Courtesy of FORD MOTOR CO.
    NOTE: Coat the O-ring at the bottom of the transmission fluid filler tube with clean automatic transmission fluid.
  2. Install the transmission fluid filler tube.
    3. Fig 2: Installing Transmission Fluid Filler Tube
    GF0006787Courtesy of FORD MOTOR CO.
  3. Install the transmission fluid filler tube nut.
    • Tighten to 10 Nm (89 lb-in).
    4. Fig 3: Installing Transmission Fluid Filler Tube Nut
    GF0006785Courtesy of FORD MOTOR CO.
  4. Install the fluid level indicator.
    5. Fig 4: Locating Fluid Level Indicator
    G03889043Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals