LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1910 (Automatic Transmission - 5R110W -- F250-F550 Super Duty) >> In-Vehicle Servicing >> Solenoid Body Assembly >> Removal

Solenoid Body Assembly: Removal

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the transmission fluid pan, gasket and filter. For additional information, refer to Fluid Pan, Gasket and Filter  in this article.
  2. Disconnect the solenoid body electrical connector.
    3. Fig 1: Identifying Solenoid Body Electrical Connector
    G03889052Courtesy of FORD MOTOR CO.
    NOTE: While lowering the solenoid body, the manual valve may fall out of the solenoid body.
  3. Remove the solenoid body.
    1. Disconnect the transmission range (TR) position sensor electrical connector.
    2. Remove the solenoid body bolts.
    3. Remove the solenoid body.
    4. Fig 2: Identifying Solenoid Body Bolts
    GF0006794Courtesy of FORD MOTOR CO.
  4. Remove the solenoid body gasket.
    5. Fig 3: View Of Solenoid Body Gasket
    G03889054Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals