LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1910 (Automatic Transmission - 5R110W -- F250-F550 Super Duty) >> In-Vehicle Servicing >> Shift Solenoids (SS) >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Some solenoid body bolts and wire loom bolts will need to be removed in order to remove affected solenoids.
NOTE: The line pressure solenoid is not serviced in the vehicle. The solenoid body will need to be removed to remove line pressure solenoid. For additional information, refer to Solenoid Body Assembly  in this section.
  1. Remove the transmission fluid pan, gasket and filter. For additional information, refer to Fluid Pan, Gasket and Filter  in this article.
  2. Disconnect the affected shift solenoid electrical connector.
    3. Fig 1: Disconnecting Affected Shift Solenoid Electrical Connector
    GF0006825Courtesy of FORD MOTOR CO.
  3. Remove the affected shift solenoid.
    • Remove the retaining E clip.
    • Remove the affected shift solenoid.
    4. Fig 2: Identifying Affected Shift Solenoid
    GF0006826Courtesy of FORD MOTOR CO.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals