LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1910 (Automatic Transmission - 5R110W -- F250-F550 Super Duty) >> In-Vehicle Servicing >> Internal Harness Service >> Removal

Internal Harness Service: Removal

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the solenoid body assembly. For additional information, refer to Solenoid Body Assembly  in this article.
  2. Disconnect the internal wiring harness.
    • Remove the 2 screws.
    • Disconnect the transmission fluid temperature (TFT) sensor electrical connector.
    • Disconnect the solenoid electrical connectors.
    3. Fig 1: Identifying Solenoid Electrical Connectors
    GF0006824Courtesy of FORD MOTOR CO.
  3. Remove the bulkhead connector O-ring seal.
    4. Fig 2: Identifying Bulkhead Connector O-Ring
    G03889120Courtesy of FORD MOTOR CO.
  4. Lift the tab twisting the bulkhead connector, push it through the solenoid body and remove the wire harness.
scientia non olet · About LEMON Manuals