Pinpoint Tests - OSC Equipped Vehicle: Notes
WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
SPECIAL TOOLS
| Illustration | Tool Name | Tool Number |
|---|---|---|
| Transmission Fluid Pressure Gauge | 307-004 (T57L-77820-A) | |
| Automotive Meter 73 III | 105-R0057 or equivalent | |
| Vehicle Communication Module (VCM) and Integrated Diagnostic System (IDS) software with appropriate hardware, or equivalent scan tool |
NOTE:
If equipped, turn the power take-off (PTO) unit off for correct test results. For a description of PTO operation, refer to Transmission Electronic Control System in this article. On-Board Diagnostic is not accessible when the PTO unit is in operation. Shift solenoid B (SSB) is on when the PTO is in operation.
Any time an electrical connector or solenoid body is disconnected, inspect the connector for terminal condition, corrosion and contamination. Also inspect the connector seal for damage. Clean, repair or install a new connector as required.