Gasoline engines
WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
- Install a new snap ring and make sure that the snap ring is fully seated in the case snap ring groove.
Gas applications: Install a new wavy snap ring so the tang ends are in the gaps to the right and to the left of the case spline as shown. The circle ID mark must be installed upwards on the left hand side.
- Check the function of the reverse clutch by applying air to the correct passage (through the case valve body worm trail) for the reverse clutch.
CAUTION:
Do not apply air pressure to move the low/reverse piston without first installing the friction plates and the snap ring, or damage to the snap ring will occur.