Fixed yoke transmissions

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Using the special tool, install a new extension housing seal.

Fig 1: Installing Extension Housing Seal Using Special Tool

Courtesy of FORD MOTOR CO.

Inspect the new output shaft nut O-ring for cuts. A new nut must be installed.

Fig 2: Inspecting New Output Shaft Nut O-Ring For Cuts

Courtesy of FORD MOTOR CO.

Using the special tool, install a new output shaft nut.
- Tighten to 200 Nm (148 lb-ft).

Fig 3: Installing Output Shaft With Special Tool

Courtesy of FORD MOTOR CO.

Install the output flange and a new bolt.
- Tighten to 130 Nm (96 lb-ft).

Fig 4: Locating Output Shaft Flange Bolt

Courtesy of FORD MOTOR CO.