LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1909 (Engine System - General Information - F250-F550 (Gasoline)) >> General Procedures >> Connecting Rod-to-Piston Clearance

Connecting Rod-to-Piston Clearance

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Measure the clearance between the connecting rod and the piston. Verify the measurement is within specification.
    • Refer to the appropriate Engine article for the procedure.
    • If out of specification, install new components as necessary. Refer to the appropriate Engine article for the procedure.
    Fig 1: Measuring Clearance Between Connecting Rod And Piston
    GF0000200Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals