LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1909 (Engine System - General Information - F250-F550 (Gasoline)) >> General Procedures >> Camshaft Surface Inspection

Camshaft Surface Inspection

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Inspect camshaft lobes for pitting or damage in the contact area. Minor pitting is acceptable outside the contact area.
    • If excessive pitting or damage is present, install new components as necessary. Refer to the appropriate Engine article for the procedure.
    Fig 1: Inspecting Camshaft Lobes
    G03983578Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals