LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1908 (Exhaust System -- F250-F550 Super Duty) >> Removal And Installation >> Exhaust Downpipe - 6.0L Diesel >> Removal >> All vehicles

All vehicles

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Exhaust fasteners are of a torque prevailing design. Use only new fasteners with the same part number as the original. Torque values must be used as specified during reassembly to make sure of correct retention of exhaust components.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.


  1. Remove the transmission crossmember. For additional information, refer to FULL FRAME AND BODY MOUNTING article.
  2. Disconnect the exhaust down pipe-to-turbo charger clamp.
  3. Disconnect the exhaust down pipe-to-catalytic converter nuts and remove the exhaust downpipe.
scientia non olet · About LEMON Manuals