RH cylinder head

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: If the components are to be reinstalled, they must be installed in the same positions. Mark the components for installation into the original locations.

Remove the hydraulic lash adjusters from the RH cylinder head.
Install the special tool onto the RH cylinder head.

Fig 1: Identifying Special Tool On Cylinder Head
Courtesy of FORD MOTOR CO.
Remove the 10 nuts and the RH exhaust manifold.
- Discard the gasket.
- Inspect the exhaust manifold. For additional information, refer to ENGINE SYSTEM - GENERAL INFORMATION article.
Fig 2: Removing RH Exhaust Manifold
Courtesy of FORD MOTOR CO.
Remove the stud bolt and the coolant tube.
- Discard the O-ring seals.
Fig 3: Identifying Coolant Tube Stud Bolt
Courtesy of FORD MOTOR CO.