LH cylinder head

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: If the components are to be reinstalled, they must be installed in the same positions. Mark the components for installation into their original locations.

Remove the hydraulic lash adjusters from the LH cylinder head.
Install the special tool onto the LH cylinder head.

Fig 1: Identifying Special Tool Onto Cylinder Head
Courtesy of FORD MOTOR CO.
Remove the 10 nuts and the LH exhaust manifold.
- Discard the gasket.
- Inspect the exhaust manifold. For additional information, refer to ENGINE SYSTEM - GENERAL INFORMATION article.
Fig 2: Removing LH Exhaust Manifold
Courtesy of FORD MOTOR CO.