LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1905 (Engine - 6.8L (3V) -- F250-F550 Super Duty) >> Installation >> Cylinder Head >> LH cylinder head

LH cylinder head

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Special Tool Onto Cylinder Head
G03920258Courtesy of FORD MOTOR CO.
  1. Remove the special tool from the LH cylinder head.
  2. Install the hydraulic lash adjusters into the LH cylinder head.
    • Lubricate the hydraulic lash adjusters with clean engine oil prior to installation.
    Fig 2: Identifying Hydraulic Lash Adjusters
    G03920399Courtesy of FORD MOTOR CO.
  3. Position a new gasket, the LH exhaust manifold and tighten the 10 nuts in the sequence shown.
    • Tighten to 25 N.m (18 lb-ft).
    Fig 3: Identifying LH Exhaust Manifold Nuts Tightening Sequence
    GF0005596Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals