LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1905 (Engine - 6.8L (3V) -- F250-F550 Super Duty) >> In-Vehicle Servicing >> Valve Springs >> Installation >> Cylinder No. 10 front intake valve spring

Cylinder No. 10 front intake valve spring

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the camshaft bearing cap and install the 2 bolts in 2 stages:
    • Stage 1: Tighten to 8 Nm (71 lb-in).
    • Stage 2: Tighten an additional 45 degrees.
    Fig 1: Identifying Bolts And Camshaft Bearing Cap
    G03920706Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals