LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1905 (Engine - 6.8L (3V) -- F250-F550 Super Duty) >> In-Vehicle Servicing >> Oil Pump >> Installation

Oil Pump: Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Do not use metal scrapers, wire brushes, power abrasive discs or other abrasive means to clean the sealing surfaces. These tools cause scratches and gouges which make leak paths. Use a plastic scraping tool to remove all traces of old sealant.
  1. Clean the sealing surfaces with metal surface prep. Follow the directions on the packaging. Inspect the mating surfaces.
    2. Fig 1: Locating Oil Pump Bolts
    G04638972Courtesy of FORD MOTOR CO.
  2. Position the oil pump and install the bolts.
    • Tighten to 10 N.m (89 lb-in).
  3. Install the oil pan. For additional information, refer to Oil Pan - Automatic Transmission  or Oil Pan - Manual Transmission  in this article.
  4. Install the timing drive components. For additional information, refer to Timing Drive Components  in this article.
scientia non olet · About LEMON Manuals