LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1905 (Engine - 6.8L (3V) -- F250-F550 Super Duty) >> In-Vehicle Servicing >> Engine Oil Pressure (EOP) Switch >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Disconnect the engine oil pressure (EOP) switch electrical connector.
  3. Remove the EOP switch.
    • To install, tighten to 18 N.m (13 lb-ft).
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals