All camshaft roller followers

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: If the components are to be reinstalled, they must be installed in their original location or engine damage may occur. Mark the components for installation into their original locations.

NOTE: Do not allow the valve keepers to fall off the valve or the valve may drop into the cylinder. If a valve drops into the cylinder, the cylinder head must be removed. For additional information, refer to Cylinder Head in this article.

NOTE: It may be necessary to push the valve down while compressing the spring.

NOTE: Lubricate the camshaft roller followers with clean engine oil prior to installation.

Fig 1: Identifying Special Tool For Removing/Installing Camshaft Roller Followers

Courtesy of FORD MOTOR CO.

Using the special tool, compress the valve spring and install the camshaft roller follower.
Repeat the previous step for each camshaft roller follower being serviced.

Depending on the valve being serviced, install the LH or RH valve cover. For additional information, refer to Valve Cover - LH or Valve Cover - RH in this article.