RH cylinder head

WARNING: This page is about a different car, the 2007 Ford Pickup and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: If the components are to be reinstalled, they must be installed in the same positions. Mark the components for installation into the original locations.

Remove the hydraulic lash adjusters from the RH cylinder heads.
Install the special tool onto the RH cylinder head.

Fig 1: Identifying Special Tool On Cylinder Head
Courtesy of FORD MOTOR CO.
Remove the 8 nuts, the 8 studs and the RH exhaust manifold.
- Discard the gaskets, the 8 studs and the 8 nuts.
- Inspect the exhaust manifold. For additional information, refer to ENGINE SYSTEM - GENERAL INFORMATION article.
Fig 2: Locating RH Exhaust Manifold Nuts And Studs
Courtesy of FORD MOTOR CO.
Remove the stud bolt and the coolant tube.
- Discard the O-ring seals.
Fig 3: Identifying Coolant Tube Stud Bolt
Courtesy of FORD MOTOR CO.