LH cylinder head

WARNING: This page is about a different car, the 2007 Ford Pickup and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: If the components are to be reinstalled, they must be installed in the same positions. Mark the components for installation into the original locations.

Remove the hydraulic lash adjusters from the LH cylinder head.
Install the special tool onto the LH cylinder head.

Fig 1: Identifying Special Tool Onto Cylinder Head
Courtesy of FORD MOTOR CO.
Remove the 2 nuts and the LH exhaust manifold shield.

Fig 2: Identifying LH Exhaust Manifold Shield Nuts
Courtesy of FORD MOTOR CO.
Remove the 8 nuts, the 8 studs and the LH exhaust manifold.
- Discard the gaskets, the 8 studs and the 8 nuts.
- Inspect the exhaust manifold. For additional information, refer to ENGINE SYSTEM - GENERAL INFORMATION article.
Fig 3: Locating LH Exhaust Manifold Nuts And Studs
Courtesy of FORD MOTOR CO.