Automatic transmission vehicles

WARNING: This page is about a different car, the 2007 Ford Pickup and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The upper 2 transmission-to-engine bolts will be installed later.

Fig 1: Installing Lower Transmission-To-Engine Bolts

Courtesy of FORD MOTOR CO.

Install the lower 5 transmission-to-engine bolts.
- Tighten to 48 N.m (35 lb-ft).
Install 4 new torque converter-to-flexplate nuts.
- Tighten to 35 N.m (26 lb-ft).
Fig 2: Identifying Convert-To-Flexplate Nuts
Courtesy of FORD MOTOR CO.
Install the cylinder block opening cover.

Fig 3: Locating Cylinder Block Opening Cover
Courtesy of FORD MOTOR CO.
Install the flexplate inspection cover and the 2 bolts.
- Tighten to 34 N.m (25 lb-ft).
Fig 4: Locating Flexplate Inspection Cover Bolts
Courtesy of FORD MOTOR CO.
Install the transmission fluid filler tube, the ground strap and the nut.
- Tighten to 12 N.m (9 lb-ft).
Fig 5: Identifying Transmission Fluid Filler Tube
Courtesy of FORD MOTOR CO.
Install the starter. For additional information, refer to STARTING SYSTEM - GASOLINE ENGINES article.

Install the transmission cooler tube support bracket and the nut.
- Tighten to 10 N.m (89 lb-in).
Fig 1: Identifying Transmission Cooler Tube Support Bracket Nut
Courtesy of FORD MOTOR CO.
Install the upper 2 transmission-to-engine bolts.
- Tighten to 48 N.m (35 lb-ft).
Fig 2: Locating Upper Transmission-To-Engine Bolts
Courtesy of FORD MOTOR CO.