RH cylinder head

WARNING: This page is about a different car, the 2007 Ford Pickup and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Remove the special tool from the RH cylinder head.

Fig 1: Identifying Special Tool On Cylinder Head
Courtesy of FORD MOTOR CO.
Install the hydraulic lash adjusters into the RH cylinder head.
- Lubricate the hydraulic lash adjusters with clean engine oil prior to installation.
Fig 2: Identifying Hydraulic Lash Adjusters
Courtesy of FORD MOTOR CO.
Install 8 new exhaust manifold studs.
- Tighten to 12 Nm (9 lb-ft).
Fig 3: Locating RH Exhaust Manifold-To-Cylinder Head Studs
Courtesy of FORD MOTOR CO.
Position a new gasket and the RH exhaust manifold and tighten the 8 new nuts in the sequence shown.
- Tighten to 25 N.m (18 lb-ft).
Fig 4: Identifying Tightening Sequence Of RH Exhaust Manifold Nuts
Courtesy of FORD MOTOR CO.
Install the coolant tube and the stud bolt.
- Tighten to 10 N.m (89 lb-in).
Fig 5: Identifying Coolant Tube Stud Bolt
Courtesy of FORD MOTOR CO.