All valve springs
WARNING: This page is about a different car, the 2007 Ford Pickup and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the spark plug for the cylinder being serviced. For additional information, refer to ENGINE IGNITION - 5.4L AND 6.8L (3V) article.
- Rotate the crankshaft until the piston for the valve being serviced is at the top of its stroke with the intake valve and the exhaust valves closed.
- Using the special tool, compress the valve spring and remove the camshaft roller follower.
- Use compressed air in the cylinder being serviced to hold both valves in position.
- Apply a minimum of 965 kPa (140 psi) of compressed air into the cylinder.
- Using the special tool, compress the valve spring and remove the valve spring retainer keys.
- Remove the valve spring retainer and the valve spring.
- Inspect the valve spring. For additional information, refer to ENGINE SYSTEM - GENERAL INFORMATION article.
CAUTION:
If the components are to be reinstalled, they must be installed in the same positions. Mark the components for installation into their original locations.
CAUTION:
If air pressure has forced the piston to the bottom of the cylinder, any loss of air pressure will allow the valve to fall into the cylinder. If air pressure must be removed, support the valve prior to removal.
CAUTION:
If the components are to be reinstalled, they must be installed in the same positions. Mark the components for installation into their original locations.
NOTE:
If a valve drops into the cylinder, remove the cylinder head. For additional information, refer to Cylinder Head in this article.