RH valve seals

WARNING: This page is about a different car, the 2007 Ford Pickup and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Remove the air cleaner and air cleaner inlet tube. For additional information, refer to INTAKE AIR DISTRIBUTION AND FILTERING article.
Remove the RH valve cover. For additional information, refer to Valve Cover - RH in this article.
Remove the cooling fan shroud. For additional information, refer to ENGINE COOLING article.
Remove the generator. For additional information, refer to GENERATOR AND REGULATOR article.
Install the special tools.

Fig 1: Identifying Special Engine Support Tools
Courtesy of FORD MOTOR CO.
Remove the 4 exhaust manifold-to-exhaust Y-pipe nuts.

Fig 2: Locating Exhaust Manifold-To-Pipe Nuts
Courtesy of FORD MOTOR CO.

CAUTION: Only use hand tools when removing the transmission mount-to-crossmember nuts or damage to the transmission mount can occur.

Fig 3: Identifying Transmission Mount-To-Crossmember Nuts

Courtesy of FORD MOTOR CO.

Loosen the transmission mount-to-crossmember nuts.

CAUTION: Only use hand tools when removing the engine support insulator nuts or damage to the engine support insulators can occur.

NOTE: RH shown, LH similar.

Fig 4: Identifying Engine Mount Nuts

Courtesy of FORD MOTOR CO.

Remove the 3 RH engine support insulator nuts, and only loosen the 3 LH engine support insulator nuts.
Using the special tools, raise the engine.

Fig 5: Identifying Special Engine Support Tools
Courtesy of FORD MOTOR CO.