RH valve seals

WARNING: This page is about a different car, the 2007 Ford Pickup and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Using the special tools, align the engine support insulator studs and lower the engine.

Fig 1: Identifying Special Engine Support Tools
Courtesy of FORD MOTOR CO.

CAUTION: Only use hand tools when installing the transmission mount-to-crossmember nuts or damage to the transmission mount can occur.

Fig 2: Identifying Transmission Mount-To-Crossmember Nuts

Courtesy of FORD MOTOR CO.

Install the transmission mount-to-crossmember nuts.
- Tighten to 103 Nm (76 lb-ft).

CAUTION: Only use hand tools when installing the engine support insulator nuts or damage to the engine support insulators can occur.

NOTE: RH shown, LH similar.

Fig 3: Identifying Engine Mount Nuts

Courtesy of FORD MOTOR CO.

Install the 6 RH and LH engine support insulator nuts.
- Tighten to 103 Nm (76 lb-ft).
Install the 4 exhaust manifold-to-exhaust Y-pipe nuts.
- Tighten to 40 Nm (30 lb-ft).
Fig 4: Locating Exhaust Manifold-To-Pipe Nuts
Courtesy of FORD MOTOR CO.
Install the RH valve cover. For additional information, refer to Valve Cover - RH in this article.
Install the generator. For additional information, refer to GENERATOR AND REGULATOR article.
Install the cooling fan shroud. For additional information, refer to ENGINE COOLING article.
Install the air cleaner and air cleaner inlet tube. For additional information, refer to INTAKE AIR DISTRIBUTION AND FILTERING article.