LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1904 (Engine - 5.4L (3V) - F250 & F350) >> In-Vehicle Servicing >> Valve Cover - RH >> Installation

Valve Cover - RH: Installation

WARNING: This page is about a different car, the 2007 Ford Pickup and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: If the valve cover is not secured within 4 minutes, the sealant must be removed and the sealing area cleaned with silicone gasket remover and metal surface prep. Follow the directions on the packaging. Allow to dry until there is no sign of wetness, or 4 minutes, whichever is longer. Failure to follow this procedure can cause future oil leakage.
    Fig 1: Applying Bead Of Silicone Gasket And Sealant In 2 Places Where Engine Front Cover Meets Cylinder Head
    G03919863Courtesy of FORD MOTOR CO.
  1. Apply a bead of silicone gasket and sealant in 2 places where the engine front cover meets the cylinder head.
  2. Position the LH valve cover and new gasket on the cylinder head and tighten the bolts in the sequence shown.
    • Tighten to 10 N.m (89 lb-in).
    Fig 2: Identifying Tightening Sequence Of Valve Cover Bolts
    G03919864Courtesy of FORD MOTOR CO.
  3. Connect the wiring harness retainers to the valve cover.
  4. Position the evaporative emissions (EVAP) canister purge valve assembly and install the 3 nuts.
    • Tighten to 10 N.m (89 lb-in).
    Fig 3: Locating Evaporative Emissions Canister Purge Valve Bracket Nuts
    G03919862Courtesy of FORD MOTOR CO.
  5. Connect the EVAP vapor tube quick connect couplings and the EVAP canister purge valve electrical connector. For additional information, refer to FUEL SYSTEM - GENERAL INFORMATION - GASOLINE AND DIESEL article.
    Fig 4: Connecting Electrical Connector And EVAP Tube Quick Connect Couplings
    G03919866Courtesy of FORD MOTOR CO.
  6. Connect the engine wiring harness retainer to the EVAP canister purge valve bracket.
    Fig 5: Locating Engine Wiring Harness Retainer
    GF0005516Courtesy of FORD MOTOR CO.
  7. Connect the vacuum hose and engine wiring harness retainers.
    Fig 6: Locating Vacuum Hose And Engine Wiring Harness Retainers
    GF0005517Courtesy of FORD MOTOR CO.
  8. Connect the crankcase vent tube quick connect coupling to the valve cover. For additional information, refer to FUEL SYSTEM - GENERAL INFORMATION - GASOLINE AND DIESEL article.
  9. Install the RH ignition coils. For additional information, refer to ENGINE IGNITION - 5.4L AND 6.8L (3V) article.
  10. If equipped, install the transmission filler tube. For additional information, refer to AUTOMATIC TRANSAXLE/TRANSMISSION - TORQSHIFT article.
scientia non olet · About LEMON Manuals