Manual transmission vehicles

WARNING: This page is about a different car, the 2007 Ford Pickup and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Remove the flywheel. For additional information, refer to Flywheel in this article.

CAUTION: Only use hand tools when loosening the LH engine mount nuts or damage to the engine mount can occur.

NOTE: LH shown, RH similar.

Fig 1: Identifying Engine Mount Nuts

Courtesy of FORD MOTOR CO.

Loosen the 3 LH engine mount nuts and remove the 3 RH engine mount nuts.

Using a suitable jack, raise and support the rear of the cylinder block.

Fig 1: Supporting Rear Of Cylinder Block
Courtesy of FORD MOTOR CO.