Automatic transmission vehicles

WARNING: This page is about a different car, the 2007 Ford Pickup and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Only use hand tools when removing the RH engine mount nuts or damage to the engine mount can occur.

NOTE: LH shown, RH similar.

Fig 1: Identifying Engine Mount Nuts

Courtesy of FORD MOTOR CO.

Remove the 6 RH and LH engine mount nuts.
Remove the nut and the starter wiring harness support bracket.

Fig 2: Identifying Cooler Tube/Electrical Harness Support Bracket Bolt
Courtesy of FORD MOTOR CO.
If equipped, remove the nut and position the transmission oil cooler lines and bracket aside.

Fig 3: Identifying Transmission Oil Cooler Lines And Bracket Nut
Courtesy of FORD MOTOR CO.
Using the special tools, raise the engine.

Fig 4: Identifying Special Engine Support Tools
Courtesy of FORD MOTOR CO.