LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1904 (Engine - 5.4L (3V) - F250 & F350) >> In-Vehicle Servicing >> Crankshaft Rear Seal >> Removal

Crankshaft Rear Seal: Removal

WARNING: This page is about a different car, the 2007 Ford Pickup and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the flexplate or flywheel. For additional information, refer to Flexplate  or Flywheel  in this article.
  2. Remove the engine rear cover plate.
  3. Using the special tools, remove and discard the crankshaft oil slinger.
    Fig 1: Removing Crankshaft Rear Oil Seal Slinger
    G03920149Courtesy of FORD MOTOR CO.
  4. Using the special tools, remove and discard the crankshaft rear seal.
    Fig 2: Removing Crankshaft Rear Seal
    G03920150Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals