LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1904 (Engine - 5.4L (3V) - F250 & F350) >> In-Vehicle Servicing >> Camshaft Roller Follower >> Removal >> All camshaft roller followers

All camshaft roller followers

WARNING: This page is about a different car, the 2007 Ford Pickup and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Rotate the crankshaft until the piston for the valve being serviced is at the top of its stroke with the intake valve and the exhaust valves closed.
    2. Fig 1: Identifying Special Tool For Removing/Installing Camshaft Roller Followers
    G03919946Courtesy of FORD MOTOR CO.
    CAUTION: If the components are to be reinstalled, they must be installed in the same positions. Mark the components for installation into their original locations.
  2. Using the special tool, compress the valve spring and remove the camshaft roller follower.
  3. Repeat the previous 2 steps for each camshaft roller follower being serviced.
  4. Inspect the camshaft roller follower. For additional information, refer to ENGINE SYSTEM - GENERAL INFORMATION article.
scientia non olet · About LEMON Manuals