LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1903 (Electronic Engine Controls - Gasoline Engine -- F250-F550 Super Duty) >> Removal And Installation >> Crankshaft Position (CKP) Sensor >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES article.
  3. Remove the accessory drive belt. For additional information, refer to ACCESSORY DRIVE article.
  4. Disconnect the A/C compressor electrical connector.
  5. Remove the 3 bolts and position the A/C compressor aside.
    • To install, tighten to 25 N.m (18 lb-ft).
  6. Disconnect the crankshaft position (CKP) sensor electrical connector.
  7. Remove the bolt and the CKP sensor. Discard the O-ring seal.
    • To install, tighten to 10 N.m (89 lb-in).
    • Lubricate the new O-ring seal with clean engine oil prior to installation.
  8. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals