LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1901 (Engine Cooling System - F250-F550) >> Removal And Installation >> Block Heater - 6.0L Diesel >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. With vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Drain the cooling system. For additional information, refer to Cooling System Draining, Filling and Bleeding  in this article.
  3. Disconnect the block heater electrical connector.
  4. Remove the block heater and discard the O-ring seal.
    • To install, tighten to 41 N.m (30 lb-ft).
    • Install a new O-ring seal.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals