Automatic transmission vehicles

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Remove the jack stand from the extension housing.

Fig 1: Removing Jack Stand From Extension Housing
Courtesy of FORD MOTOR CO.
Install the transmission mount.
- Tighten to 95 N.m (70 lb-ft).
Fig 2: Locating Transmission Mount
Courtesy of FORD MOTOR CO.
Position the crossmember and loosely install the 2 transmission mount nuts.

Fig 3: Locating Transmission Insulator-To-Crossmember Support Nuts
Courtesy of FORD MOTOR CO.
Install the 3 LH crossmember nuts.
- Tighten to 70 N.m (52 lb-ft).
Fig 4: Locating LH Crossmember Nuts
Courtesy of FORD MOTOR CO.
Install the RH crossmember nuts.
- Tighten to 70 N.m (52 lb-ft).
Fig 5: Locating RH Crossmember Nuts
Courtesy of FORD MOTOR CO.

Tighten the transmission mount-to-crossmember nuts.
- Tighten to 94 N.m (69 lb-ft).
Fig 1: Locating Transmission Mount-To-Crossmember Nuts
Courtesy of FORD MOTOR CO.