LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1893 (Transfer Case - F250-F550 Super Duty) >> In-Vehicle Servicing >> Transfer Case Shift Lever >> Removal

Transfer Case Shift Lever: Removal

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Shift the transfer case into 4H.
  2. Remove the screws that attach the bezel and boot assembly to the floor.
    Fig 1: Identifying Bezel And Boot Assembly Screws
    G03909667Courtesy of FORD MOTOR CO.
  3. Remove the shift lever bolts that attache the shift lever to the transfer case control lever assembly. Remove the shift lever, and the bezel and boot as an assembly.
    • Slide the bezel and boot assembly upward on the shift lever, remove the shift lever bolts.
    Fig 2: Locating Shift Lever Bolts
    GF0007510Courtesy of FORD MOTOR CO.
  4. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  5. Disconnect the control rod from the lower shifter arm.
    Fig 3: Disconnecting Control Rod From Lower Shifter Arm
    GF0007511Courtesy of FORD MOTOR CO.
  6. Remove the transfer case control lever pivot bolt and the transfer case control lever assembly. Discard the bolt.
    Fig 4: Removing Transfer Case Control Lever Pivot Bolt
    GF0007512Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals