LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1893 (Transfer Case - F250-F550 Super Duty) >> In-Vehicle Servicing >> Transfer Case Rear Output Shaft Seal >> Installation

Transfer Case Rear Output Shaft Seal: Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using the special tools, install a new rear output seal.
    Fig 1: Installing Rear Output Seal
    GF0007500Courtesy of FORD MOTOR CO.
  2. Using the special tool to prevent the flange from turning, install the rear flange and a new rear output flange nut.
    • Tighten to 251 N.m (186 lb-ft).
    Fig 2: Identifying Rear Output Flange Nut
    GF0007501Courtesy of FORD MOTOR CO.
    3. NOTE: Align the index marks made during removal.
  3. Connect the rear driveshaft to the transfer case.
  4. Install 4 new rear driveshaft flange bolts.
    • Tighten to 102 N.m (75 lb-ft).
    Fig 3: Identifying Rear Driveshaft Flange Bolts
    GF0007502Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals