LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1892 (Transfer Case - Four Wheel Drive (4WD) Systems -- F250-F550 Super Duty) >> Removal And Installation >> Hublock >> Removal >> All vehicles

All vehicles

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Loosen the hublock screws 1 to 2 turns.
  2. Use a small pry bar around the entire hub flange to release the gasket.
    3. Fig 1: Locating Entire Hub Flange
    GF0007481Courtesy of FORD MOTOR CO.
  3. Remove and discard the hublock screws.
    4. Fig 2: Locating Hublock Screws
    GF0007482Courtesy of FORD MOTOR CO.
    NOTE: Wiggle the axle shaft while sliding the hublock off of the splines to ease removal.
  4. Use a small pry bar around the entire hub flange and remove the hublock from the wheel hub.
  5. Remove the old gasket material completely and discard the O-ring.
  6. Clean the O-ring seal contact area as necessary to provide a good seal.
scientia non olet · About LEMON Manuals