LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1892 (Transfer Case - Four Wheel Drive (4WD) Systems -- F250-F550 Super Duty) >> Removal And Installation >> Hublock >> Installation >> All vehicles

All vehicles

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install a new gasket and O-ring on the hublock.
    2. Fig 1: Locating Gasket And O-Ring
    GF0007483Courtesy of FORD MOTOR CO.
  2. Rotate the hublock dial clockwise to the LOCK position, then apply the specified grease to the inner and outer splines.
    3. Fig 2: Locating Hublock Inner And Outer Splines
    GF0007484Courtesy of FORD MOTOR CO.
    NOTE: Wiggle the axle shaft while sliding the hublock on the splines to ease installation.
  3. Slowly rotate the wheel hub while installing the hublock into the hub.
    • Push the hublock in firmly by hand to seat the O-ring seal completely.
  4. Rotate the hublock dial counterclockwise to the AUTO position.
    • Be sure that the axle shaft turns freely.
  5. Tighten the new hublock screws to 6 Nm (53 lb-in).
scientia non olet · About LEMON Manuals