LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1891 (Rear Suspension -- F250-F550 Super Duty) >> Removal And Installation >> Wheel Studs - Single Rear Wheel >> Installation

Wheel Studs - Single Rear Wheel: Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the wheel stud in the flange making sure that the serrations are aligned with those made by the original wheel stud.
  2. Using the special tool, install the wheel stud.
  3. Install the rear wheel hub assembly. For additional information, refer to REAR DRIVE AXLE/DIFFERENTIAL - DANA 80 article.
    Fig 1: Installing Wheel Stud Using Special Tool
    GF0006184Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals