LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1891 (Rear Suspension -- F250-F550 Super Duty) >> Removal And Installation >> Wheel Studs - Dual Rear Wheel (DRW) >> Installation

Wheel Studs - Dual Rear Wheel (DRW): Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the new wheel stud aligning the serrations in the wheel extension made by the original wheel stud.
    Fig 1: Locating Wheel Stud Aligning Position
    GF0006130Courtesy of FORD MOTOR CO.
  2. Place 4 washers over the outside end of the wheel stud and thread a standard wheel nut with the flat side against the washers. Tighten the wheel nut until the wheel stud seats against the back side of the wheel extension.
    Fig 2: Identifying Wheel Nut
    GF0000735Courtesy of FORD MOTOR CO.
  3. Remove the wheel nut and washers.
scientia non olet · About LEMON Manuals