LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1890 (Driveshaft -- F250-F550 Super Duty) >> Removal And Installation >> Driveshaft - Rear, One-Piece, Four Wheel Drive (4WD) >> Removal >> Vehicles with split pin yoke

Vehicles with split pin yoke

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove and discard the 4 rear driveshaft-to-transfer case bolts and the 2 U-joint retainers.
    Fig 1: Locating Rear Driveshaft-To-Transfer Case Bolts
    GF0006228Courtesy of FORD MOTOR CO.
    2. NOTE: It may be necessary to unseat the bearing cup assemblies by tapping on the yoke or bearing cup with a plastic or rubber soft-faced hammer.
  2. Disconnect the driveshaft from the yoke.
scientia non olet · About LEMON Manuals