LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1890 (Driveshaft -- F250-F550 Super Duty) >> Removal And Installation >> Driveshaft - Rear, One-Piece, Four Wheel Drive (4WD) >> Removal >> Vehicles with circular flange

Vehicles with circular flange

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove and discard the 4 bolts.
    2. Fig 1: Locating Bolts
    GF0006229Courtesy of FORD MOTOR CO.
    NOTE: The driveshaft yoke fits tightly on the rear axle pinion flange pilot. Pry only in the slot on each side of the driveshaft yoke, with a suitable tool, to disconnect the yoke from the flange.
    NOTE: It may be necessary to tap the driveshaft yoke with a plastic or rubber soft-faced hammer if a pry area is not present on the driveshaft yoke.
  2. Using a suitable tool, disconnect the driveshaft flange and remove the driveshaft from the vehicle.
scientia non olet · About LEMON Manuals