LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1890 (Driveshaft -- F250-F550 Super Duty) >> Disassembly And Assembly >> Driveshaft Universal Joint - Single Cardan, Flange Yoke >> Disassembly >> Bearing cup removal

Bearing cup removal

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: If necessary, use a pair of pliers to remove a bearing cup that fails to press out all the way.
  1. Remove the bearing cups and the flange.
    1. Position the flange in the special tool.
    2. Press out a bearing cup.
    3. Rotate the flange 180 degrees.
    4. Press on the spider to remove the remaining bearing cup.
    5. Remove the flange.
    2. Fig 1: Removing Bearing Cups And Flange
    GF0006263Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals