LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1890 (Driveshaft -- F250-F550 Super Duty) >> Disassembly And Assembly >> Driveshaft Universal Joint - Single Cardan, Flange Yoke >> Assembly >> Bearing cup installation

Bearing cup installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Install the Universal Joint Kits as complete assemblies only. Do not mix components from other kits.
    Fig 1: Installing Bearing Cup Using Special Tool
    GF0006265Courtesy of FORD MOTOR CO.
  1. Install a new spider and bearing cups.
    1. Start a new bearing cup in the driveshaft yoke.
      • Check the needle bearings for correct positioning.
    2. Position the new spider in the driveshaft yoke.
    3. Position the driveshaft yoke in the special tool.
    4. Press the bearing cup to just below the snap ring groove.
    • Repeat to install the new bearing cup on the opposite side of the driveshaft yoke.
scientia non olet · About LEMON Manuals