LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1890 (Driveshaft -- F250-F550 Super Duty) >> Disassembly And Assembly >> Driveshaft Universal Joint - Rear Slip Yoke >> Assembly >> Slip-yoke installation

Slip-yoke installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Inspect the driveshaft slip-yoke. Install a new yoke, if necessary.
  2. Install the slip-yoke and new bearing cup.
    1. Start a new bearing cup in the slip-yoke.
      • Check the needle bearings for correct positioning.
    2. Position the slip-yoke on the spider.
    3. Position the assembly in the special tool.
    4. Press the bearing cup to just below the snap ring groove.
    3. Fig 1: Installing Slip-Yoke And Bearing Cup
    GF0006259Courtesy of FORD MOTOR CO.
  3. Remove the shaft from the special tool, and install the new snap ring.
Fig 2: Identifying Snap Ring
GF0000800Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals