LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1890 (Driveshaft -- F250-F550 Super Duty) >> Disassembly And Assembly >> Driveshaft Universal Joint - Rear Slip Yoke >> Assembly >> Opposite bearing cup installation

Opposite bearing cup installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Repeat Bearing cup installation in this procedure to install the new bearing cup and snap ring on the opposite side of the shaft yoke.
    2. Fig 1: Installing Bearing Cups
    GF0000801Courtesy of FORD MOTOR CO.


  1. Repeat Slip-yoke installation in this procedure to install the new bearing cup and snap ring on the opposite side of the driveshaft slip-yoke.
scientia non olet · About LEMON Manuals